7
．
Other Functions
7
−
1
Sleep Function
NOTE
The instrument consumes small amount of current in the Sleep
(power-down) mode. Make sure to turn the Function Selector
switch to the "OFF" position, when the instrument is not in use.
This is a function to prevent the instrument from being left powered
on in order to conserve battery life. This function causes the
instrument to switch to the Sleep (powered-down) mode about 10
minutes after the last switch or button operation.
To exit the Sleep mode, press any button or turn the Function
Selector switch back to "OFF", then to any other position.
［How to disable the Sleep function］
Powering the instrument on with the Data Hold button pressed
disables the Sleep function. "P.OFF" is shown on the display for
about 3 seconds to indicate this.
To enable the Sleep function, turn the Function Selector switch
back to "OFF", then to any other position.
NOTE
◇The Sleep function is disabled while the output plug is inserted
into the OUTPUT terminal. When the output plug is disconnected
from the terminal, the Sleep function is enabled in about 10
minutes.
― 21 ―
6
−
7
MAX Measurement (Response time: 400ms)
The MAX measurement mode is used to display a maximum reading
over a certain period of time. This function is available on all ranges
other than Ω ranges.
DANGER
●Never make measurement on a circuit in the following categories;
Measurement category Ⅳ(CAT.Ⅳ)
: over AC/DC600V
Measurement category Ⅲ(CAT.Ⅲ)or lower: over AC750/DC1000V
●Do not make measurement with the battery compartment cover
removed.
●Do not make measurement with the test leads connected to the
instrument.
● Keep your fingers and hands behind the barrier during
measurement.
a. Set the Function Selector switch to the desired position.
b. Press the Mode button to select the MAX measurement mode.
腋胙腴
should be shown on the display.
c. In order to take a correct reading, press the Zero Adjust/Reset
button once after clamping the jaws onto the conductor or
connecting the test leads to the circuit under test.
d. The display shows the maximum reading during measurement
e. Press the Zero Adjust/Reset button once again to return to the
normal measurement mode.
NOTE
◇Data Hold function is disabled in MAX measurement mode.
◇ For measurement over a period more than 10 minutes, disable the
Sleep function according to the instruction in section
7-1: Sleep
Function
. Otherwise, the instrument automatically turns itself off
in about 10 minutes.
― 20 ―
Byram
Labs
