Step 6:
Add wires to the IN, OUT, LED, POS, and the Ground eyelet
located in the top of the board. . Start by cutting 4 3.5” pieces of wire.
Strip 1/4” off each end and tin the ends. Tinning means to apply some
solder to the stripped ends of the wires. This keeps the strands from fraying
and primes the wire for soldering. Load the wires in from the top and solder
on the bottom of the PCB.
Summary of Contents for Large Beaver NYC
Page 16: ...Step 2 Install the enclosed 1 4 jacks to the enclosure...
Page 20: ...Step 2 Wire the PCB to the foot switch and jacks as shown...
Page 22: ...For hi res schematic visit http www byocelctronics com largebeavernycschematic pdf...
Page 23: ...Please visit http byocelectronics com board for any technical support Copyright 2018 BYOC Inc...
