Step 8:
Add wires to the IN, OUT, RING, and two Ground eyelets. Start by cutting
four 2.5” pieces of wire, and one 1.5” piece. Strip 1/4” off each end and tin the ends.
Tinning means to apply some solder to the stripped ends of the wires. This keeps the
strands from fraying and primes the wire for soldering. Solder a 2.5” piece of wire to
each of the IN, OUT, and Ground eyelets on the PCB. Solder the 1.5” piece to RING
eyelet on the PCB. Load the wires in from the top and solder on the bottom of the PCB.
Summary of Contents for Classic Delay
