BYD F7-1, F7-2, F7-3
Owner’s Manual
Instrument and Controller Operation 1-
46
≤500
Long
Sensor detecting range
When the car is reversing, all sensors
work.
The figure shows the detecting range
of the sensor. Above range is limited,
check the surrounding environment
first and then back slowly.
Sensor detecting info
Certain car state and surroundings
may affect the sensor in detecting
obstacles.
The specific conditions that may have
impacts are listed below:
There is dirt, water, or mist on the
sensor;
The sensor has snow on it or is
frozen;
The sensor is covered in any way;
The car rolls over or is overloaded;
In particularly bumpy roads, slopes,
gravel pavement or grass;
The sensor is re-sprayed;
Due to vehicle horn, engine sound
of motorcycle, air brake sound of
large vehicles, or any other noises
that will cause ultrasonic, the car
surrounding is very noisy;
There is another vehicle equipped
with parking assistant system
nearby;
The car is installed with traction
ring;
The bumper or the sensor has
been strongly impacted;
The car is approaching to a higher
or zigzag road edge;
In the burning sun or cold weather;
Installation is non-original and is
lower than the original suspension.
In addition to the above situation, the
sensor may not be able to correctly
determine the actual distance due to
the shapes of some objects. The
shape and material of the obstacle
may impede the detection of the
sensor. Pay particular attention to the
following obstacles.
Wires, fences, ropes, etc.;
Cotton, snow and other materials
that absorb radio waves;
Objects that have sharp edges and
corners;
Low obstacles;
The obstacles that the upper part
stretching outward toward the car;
Objects under the bumper;
Objects near the vehicle;
The staff that near the car
About 600mm
About 1200mm
