NÜO Flux Manual
Installation
7
NÜO FLUX
Installation on built walls
1) Using a level, make a hole in the wall for the rear case measuring 82 x 82 mm and 52 mm deep.
Do not forget to pass the reader cable through.
Grout the hole with plaster and place the rear case in the hole.
82
82
52
Plaster
Place the magnet at the top. This magnet will work as a tamper.
Recommended height for installation is between 1.2 and 1.5 m.
2) Remove the NÜO FLUX reader front glass
panel using the suction cup supplied. Place
the suction cup in a corner for ease of oper-
ation.
3) Pass the cable through the opening made
and attach the reader to the rear case using
the screws supplied as shown in the drawing.
Finally, replace the front glass panel.
1.
Installation on working surfaces:
The NÜO FLUX reader can be flush mounted in various environments. The various installation methods
are described below, covering built walls, plasterboard walls, and integration into other equipment such as
turnstiles or gates:
Summary of Contents for NUO FLUX
Page 1: ...Manual 41762 42039 NÜO FLUX ...
Page 2: ...2 ...
