9 Rechargeable batteries and chargers
Batteries
The batteries are charged with the external charger.
Connect the charger to the charging port on the backside of the
e-Bikelifter and to a 230V / 110V – 50-60 Hz power source.
The batteries should be charged daily, as total discharge can damage the
batteries or their lifetime.
The batteries are charged using the external charger. Connect the charger
to the charging port on the back of the e-bike lifter and to a 230 V/110 V -
50-60 Hz power source. Although the device charges both when switched
on and when switched off, the e-bike lifter should not be used while
charging!
The batteries should be charged regularly, as a total discharge can
damage the batteries or reduce their lifetime. If a deep discharge does
occur, charge the batteries for min. 4 hours before using the e-bike lifter
again. Workshops are recommended to charge the e-Bikelifter on week-
ends.
A full battery charge, allows approx. 80 cycles with complete lifting and
lowering of the maximum load of 30 kg!
Charger
The charger automatically charges the batteries and switches off when the batteries are fully charged.
Charging the batteries takes approx. 5 hours.
Charger indicator:
n
Red indicator:
The charger is connected to main power and charging.
n
Green indicator:
Float charging and ready for use.
Safety when charging
Use only original charger. Check that the wires are in good condition, connected properly
before applying power. Make sure there are no dirt or water in the plug.
13
