FRAME 35 RAIL
ASSEMBLY GUIDE
~
1
6
2
7
4
3
5
TOOL LIST: Masking tape, drill and included drill bit.
Take out your enclosed drilling guide. The drilling guide can be used for both Frame 35
single and double.
This package contains: 1x Frame rail, 2x screws and 1x drill bit.
Locate the side on your Frame box, facing down when mounted on the wall. Place a
piece of masking tape, on each side where you are about to drill the hole, using the drill
guide to help you place the tape.
Place the drilling guide in the first corner you would like to drill. Please make sure that
the two arrows are facing the front corner. Remember at first, only to drill the hole that is
marked with a dashed circle, as shown in the picture to the left.
Drill the hole from the bottom side and up. Make sure to keep you drill bit in a 90 degree
angle, towards the surface. Do not put a pressure load on the drill bit while drilling.
Repeat the entire step 1-4 in the opposite corner of the box.
NB. Please note when mounting a Frame rail for a Frame35 double, only to make one
hole per Frame box.
Remove the masking tape and use the supplied screws to mount the Frame Rail.
You are done. Enjoy!
4
5
6
7
3
2
1
X 1
X 1
X 2
1x Frame Rail
1x Drill bit
2x Screws
