STEP- 06
Then keep the table top up side up, Now your table is ready for use.
NOTE :- PHOTO FOR REFERENCE ONLY
STEP- 03
Now take one assembled leg & leg base then insert leg into the provided slot
( Important : Keep the slot given
on leg base facing inside as shown in picture above)
Now tighten the leg from both sides with given bolt and washer by
ellen key.Repeat the same with other assembled leg & leg base.
STEP- 04
Now fix the bottom support with leg base by screwing in
the given ellen bolt by ellen key.
STEP- 05
Place the metal angle near the leg as shown in picture. Match the hole of angle with hole of insert. Tighten the
metal angle with pen head allen bolt with washer by allen key. Don't tighten fully, tighten the metal angle with leg by screwing
in given wooden screw by screw driver. Tighten screw fully.
BOTTOM SUPPORT
