2009/01 - Indice de révision : C - Code : 0026690
14/32
Remove the diffuser and cover the
opening of the tube with adhesive
tape.
ASSEMBlY OF ThE FILTRE
1
Check that the drain valve is
closed.
Fill the pump with water until the
water level is 5 cm above the
laterals.
2
3
Fit the o-rings into the grooves on
the bulkhead fittings.
4
Wind Teflon tape 4 times around the
threading on the pressure gauge,
remove the plug on the multiport
valve and screw the pressure gauge
into this position.
5
Fit the multiport valve: position the
lower fitting first, then the upper
fitting. Tighten the nuts moderately.
6
Assemble the air bleed valve on
the lid.
7
Install the lid and lid o-ring.
To facilitate assembly, wet the seal
or use the lubricant, Magic Lube
(code 1397200).
Caution: the use of any other type
of lubricant is prohibited.
8
*
Valve available as an option
Pour the sand (granulometry
0.6/1.25) in carefully to avoid
damaging the laterals.
Remove the tape and put the
diffuser back in position.
*
*
*
