BWI Eagle 38UL-2000-DC, Manual

Page: 7 / 10

38UL-2000-DC
Page 6
RELAY MODES OF OPERATION
Auto Reset (Maintained Momentary)
When signal is received from an authorized transmitter, the relay will energize. The relay will maintain
the energized state as long as the transmitter is sending the signal. The relay de-energizes when the
transmitted signal stops.
Toggle Reset (Toggle Latch)
When a signal is received from an authorized transmitter, the relay will energize and latch. The relay
stays energized until the same signal is received again, at which time it unlatches and de-energizes.
Latching Reset (True Latch
When a signal is received from an authorized transmitter, the relay will energize and latch. The relay
stays energized until a different signal is received from the transmitter, at which time it unlatches and
de-energizes. i.e.
– Transmission from Input 1 of authorized transmitter energizes and latches relay 1.
Transmission from Input 2 of an authorized transmitter de-energizes relay 1.
RELAY & FREQUENCY SETUP
The unit is shipped from the factory
with SEL1 switches in the open
positions. All four relays will operate as
maintained momentary and unit is
receiving commands on frequency
one. If you wish to change these
default settings, follow the instructions
below:
1. *IMPORTANT*
Disconnect power from unit
2. Remove top cover.
3. Select desired relay operation
and/or frequency using the
table.
4. Reattach cover.
5. Reconnect power to unit.
6. Programming is complete.
RELAY CONFIGURATION
SEL1
SW#
OPEN CLOSED
SW1
Relay #1 momentary
(default)
Relay #1 toggle/latch
SW2
Relay #2 momentary
(default)
Relay #2 toggle/latch
SW3
Relay #3 momentary
(default)
Relay #3 toggle/latch
SW4
Relay #4 momentary
(default)
Relay #4 toggle/latch
Maintained Momentary
– Relay mimics button or input –
when depressed or closed, relay will be energized; when
released, relay de-energizes.
Toggle Latch
– Relay changes and holds its state each time
the corresponding button or input is depressed or closed.
FREQUENCY SETUP
NETWORK
FREQUENCY
SW5 SW6 SW7
1 (default) OPEN OPEN OPEN
2 CLOSED OPEN OPEN
3 OPEN CLOSED OPEN
4 CLOSED CLOSED OPEN
5 OPEN OPEN CLOSED
6 CLOSED OPEN CLOSED
7 OPEN CLOSED CLOSED
8 CLOSED CLOSED CLOSED
Note
– SW8 & SW9 not used on this model