BroadcastVision Entertainment : www.broadcastvision.com
Tel (888) 330-4283, Email: [email protected]
Page 2
PROGRAMMING INSTRUCTIONS
1) PROGRAMING PRESETS CHANNELS
a) Press and Hold CHANNEL DOWN and VOLUME DOWN simultaneously for 5 seconds. A
decimal point will appear in each corner of the frequency display indicating you are in the
Preset Channel Program.
b) Select the frequency you wish to set using the Channel Up/Down Buttons.
c) Select the Preset position number (1-52) you wish that frequency to be set to using the
Volume Up/Down buttons.
d) Press the EQ button to save the frequency to the preset. You will automatically advance to
the next preset channel. There are 52 preset channel positions available.
e) To delete a preset, press and hold the ‘EQ’ button until the display flashes. It is easiest to
start with the lowest channel to be erased since the presets will automatically increment.
f) Press and Hold CHANNEL DOWN and VOLUME DOWN simultaneously for 5 seconds to
EXIT Preset Channel Programming Mode.
HEADPHONE JACK REPLACEMENT
1) Unscrew the Headphone Access Door retaining screw. The screw will remain captured in
the door.
2) Open the hinged Access Door.
3) Using thumb nail or flat blade screw driver pry the headphone jack at its end until it comes
loose on the pin, and then remove the old jack.
4) Insert a new headphone jack over the pin and push onto the pin until it fully seats.
5) Close the door and insure the pin is aligned in the hole of the door. Use a small screw driver
if necessary to insure it is centered in the hole in the door.
6) Secure the Headphone door by using the door screw.
