2
Figure 1 - Contents of Box
Figure 2
Figure 3
Figure 4
Step B: Slide
Handle Onto Frame
And Line Up Holes
Step C: Insert Lower Linkage Into
Restrictor Plate and Rotate To This Position
opposite view, assembled
Step D: Place Linkage Plate Assembly Over
End of Lower Linkage as Shown in Inset
Rain Cover And Hardware Kit Are Not Shown
Screen
Control Handle
Assembly
Linkage Plate Assembly
Handle Assembly
Upper
Linkage
Lower Linkage
Preassembled
Spreader
Rear Deflector
Assembly
TOOLS NEEDED FOR ASSEMBLY
• (2) 10mm Wrenches
• (2) 1/2 in Wrenches
Contents of Box – Figure 1
Check contents of box against the parts list to make sure all
components are included. When ordering replacement or spare
parts refer to the parts list for part numbers.
Fig. 4
C.
Carefully insert the Lower Linkage into the Restrictor Plate
underneath the Hopper as shown. (The Lower Linkage has two
bent ends & the Upper Linkage has one threaded end).
Figure 1 - Contents of Box
Figure 2
Figure 3
Figure 4
Step B: Slide
Handle Onto Frame
And Line Up Holes
Step C: Insert Lower Linkage Into
Restrictor Plate and Rotate To This Position
opposite view, assembled
Step D: Place Linkage Plate Assembly Over
End of Lower Linkage as Shown in Inset
Rain Cover And Hardware Kit Are Not Shown
Screen
Control Handle
Assembly
Linkage Plate Assembly
Handle Assembly
Upper
Linkage
Lower Linkage
Preassembled
Spreader
Rear Deflector
Assembly
Attaching the Handle, Linkage Plate Assembly,
and Lower Linkage – Figures 2 – 5
A.
Remove contents from box and place the preassembled
portion of the spreader upright on its wheels
B.
Slide the Handle onto the spreader frame & line up the holes
Figure 1 - Contents of Box
Figure 2
Figure 3
Figure 4
Step B: Slide
Handle Onto Frame
And Line Up Holes
Step C: Insert Lower Linkage Into
Restrictor Plate and Rotate To This Position
opposite view, assembled
Step D: Place Linkage Plate Assembly Over
End of Lower Linkage as Shown in Inset
Rain Cover And Hardware Kit Are Not Shown
Screen
Control Handle
Assembly
Linkage Plate Assembly
Handle Assembly
Upper
Linkage
Lower Linkage
Preassembled
Spreader
Rear Deflector
Assembly
Fig. 2
Fig. 1
Figure 1 - Contents of Box
Figure 2
Figure 3
Figure 4
Step B: Slide
Handle Onto Frame
And Line Up Holes
Step C: Insert Lower Linkage Into
Restrictor Plate and Rotate To This Position
opposite view, assembled
Step D: Place Linkage Plate Assembly Over
End of Lower Linkage as Shown in Inset
Rain Cover And Hardware Kit Are Not Shown
Screen
Control Handle
Assembly
Linkage Plate Assembly
Handle Assembly
Upper
Linkage
Lower Linkage
Preassembled
Spreader
Rear Deflector
Assembly
Fig. 3
D.
Insert the other end of the Lower Linkage into the front hole
on the Linkage Plate Assembly
E.
Attach the Linkage Plate Assembly and Handle to the Frame
using two M6x40 bolts as shown (see Fig. 5 on next page).
Figure 6 shows the lower linkage assembled (for reference).
NOTE:
The Lower Linkage must be attached to the restrictor
and the Linkage Plate Assembly before the Assembly is
attached to the frame. If the Linkage Plate Assembly is attached
to the Frame without the Lower Linkage, the Lower Linkage will
be very difficult to assemble and may cause the restrictor plate
to be broken during assembly