2
E.
Center the spreader on the truck with the chute mount about
14" to the rear edge of the bed.
F.
Chute assembly. Assembly chute to hopper following
instructions shown in Fig. 2 – Fig. 3
G.
Slide spreader forward or backwards to make sure that chute
doesn’t interfere with any part of the truck. Remove one pin and
rotate chute as shown in Fig. 4. Make sure that chute doesn’t hit
any part of the truck.
H.
Bolt the spreader to the vehicle frame through the lengths
of lumber using the holes located in each of the four (4) side
gussets. Use 1/2" SAE Grade 5 hardware as required by vehicle
application.
I.
In addition secure the spreader to the vehicle by attaching the
four (4) tie-down eyes located at each corner of the spreader to
the vehicle’s factory installed anchor points using suitable tie-
down devices.
• The spreader must be securely fastened to the frame of the
vehicle.
• Verify with the vehicle’s manufacturer that the factory installed
anchor points are designed for tie-down of such load.
• Periodically check that the spreader mounting hardware is
securely tightened, retighten if necessary.
Use all
tie-downs
to lift
spreader
Fig. 1
Slide chute on
chute attachment
Align holes
Fig. 2
Fig. 3
Secure chute
using pins
#3033174
Fig. 4
Rotate chute
