www.buyersproducts.com
Phone (440) 974-8888
Fax 800-841-8003
2
Fig. 4
Fig. 5
4.
Preassemble the front Crossbar.
If desired and not
preassembled, install the carriage bolt from Bolt Set
E into the Divider's Mounting Sleeve then Slide into
the slot of the Cross Bar. Attach the Divider and then
re-peat for a second Sleeve. Next, slide one M10*25
Carriage Bolt (Bolt Set C) into the slot of the Cross Bar
(4), then slide one Rubber V Pad Assembly (items 8 and
9) onto the end of the Cross Bar, then slide another
M10*25 Carriage Bolt (Bolt Set C) into the slot of the
cross bar. Next, position the M10*25 Carriage Bolts in
the notches of the Rubber V Pad Assembly and secure.
Repeat this step for the other end of the Cross Bar. (Fig.
4 & Fig. 5)
5.
Preassemble Crossbars 2 and 3.
If desired and not
preassembled, install the carriage bolt from Bolt Set E
into the Divider's Mounting Sleeve then Slide into the
slot of the Cross Bar. Attach the Divider and repeat
for a second Sleeve. Next, slide four M10*25 Carriage
Bolts (Bolt Set C) into the slot of a Cross Bar and
position them near the center. (These bolts will be used
to attach Post A (1) and Post B (2).) Slide one additional
M10*25 Carriage Bolt into the slot at each end of the
Cross Bar then slide one Rubber V Pad Assembly (8
and 9) and another M10*25 Carriage Bolt on each end.
Position the M10*25 Carriage Bolts in the notches of the
Rubber V Pad Assemblies and secure with Bolt Set C.
Repeat this step for the third Crossbar. (Fig. 4 & Fig. 5)
6.
Position Post A (1) and Post B (2) on the truck bed
rails with the long part of their mounting feet toward
the center of the bed. Insert J-hooks (5) up through the
mounting holes and secure with the Nuts and Washers
from Bolt Set E. Once in position, tighten to ensure that
J-Hooks are holding the foot tightly against the bed
rails. (Fig. 6)
Fig. 6
7.
Install the two Cross Bars with the four extra bolts
onto the Posts by placing the bolts through the holes
in Posts and secure with Bolt Set D. Attach the Side
Rails to the Cross Bars with M10*25 Carriage Bolts
through Rubber V Pad Assemblies and secure with
Bolt Set B. (Fig. 6)
NOTE: The Posts may need to be
repositioned in order to line up holes when securing
to the Side Rails.
8.
Measure Side Rail to Side Rail while Squaring and
leveling all components. Tighten all hardware securely.
Install a End Plug (7) into each end of the three Cross
Bars.
NOTE: The Side Rails may need adjusted to
provide room for installing the Plugs.
