Quality since 1946
3
Wing on the rubber cutting edge from the rear.
Drill two 3/4” holes through the rubber cutting
edge where marked.
10.
Remove the wing from the plow and bolt the
cutting edge to the wing using the 1/2” carriage
bolts, 5/8” flat washers and nuts supplied. Re-
assemble the Pro-Wing to the plow.
11.
Repeat steps 2 through 10 for the passenger’s
side Pro-Wing.
12
. Blade guides (not included) can be bolted on
when desired. See figure 6.
rotate the wing through the plow blade hole.
Assemble 5" x 5” washer over the pin and secure
the wing to the plow with three of the supplied
lynch pins. The 7/8” flat washers supplied are to be
used to remove any play between the Pro-Wing pin
and the 5" x 5” washer.
9.
Verify the plow’s cutting edge on flat ground
and the a-frame either mounted to the truck or
level with the ground. Hold rubber cutting edge
tightly against the ground, the plow’s cutting edge
and the Pro-Wing as shown in figure 6. Mark the
location of the two holes in the bottom of the Pro-
.22
1.10
.34
FIGURE 5.
APPROXIMATE LOCATION OF
WING AFTER INSTALLATION.
FIGURE 6.
LOCATION OF CUTTING EDGE.
BLADE GUIDE INSTALLATION.
