Usage of product
Usage of product
How to Use
V. If the glass stew pot is needed
-Put the ingredients into the stew pot and add some
water.
Make an installation as shown on the page 8.
VI. Installation of the kettle lid
-Lift the bracket together with the
stew pot and install it on the kettle.
-For your attention! Please make
sure the triangle mark on the
bracket aligns with the one on the
handle of the glass body, otherwise,
it is not installed properly.
VII. Put the kettle on the base
-Please dry the water at the bottom of the pot and
on the base.
-The base must be placed on a flat, clean, heat-
resistant table.
-Exclusive base must be used with the body of the
Health-care beverage maker.
-Do not use if there is no water in the kettle.
VIII. Plug in the power
-When the kettle is energized, the buzzer makes a
noise, the button light flashes and turns off later,
indicating that the device is in standby mode, and
the function can be started.
Boiling
Two ways to enter the mode of boiling
water:
1. Press the 'Boil' button, and then
the 'Start/Pause' button, the mode of
'Boil' starts.
Note: After pressing the 'Boil' button, the
light turns on and the 'Start/Pause'
button flashes, which prompts the need to
press it. Then it enters the mode of
'Boiling' with the 'Start/Pause' button light
turns on after press.
2. Press the 'Start/Pause' button, then the
'Boil' button to start the mode of 'Boil'.
Note: Firstly press the 'Start/Pause' button, it
turns on and other function button lights turn
off after flashing, which prompts to start
selection of function. Then it enters the mode
of 'Boil' with the 'Boil' button light turns on
after press.
