
12
13
4. Method of Use of Blender Mixer
■
Opening the Cover.
Hold the blender mixer and grip the lid hole, and unlock the lid by turning
it
clockwise, and lift it up to open the cover.
■
Closing the Cover.
Put the cover into the blender mixer by gripping the lid opening with
hands, and close the cover by turning it counterclockwise until the “click”
sound is made.
(The locking is OK, if the blender mixer and the cover can be lifted up
together by lifting up lid opening.)
■
Putting Food Material
Pour the food material inside the container through the lid opening.
■
Connecting the Blender with Blender Mixer
Keep the blender mixer on the flat area. And close the
feeding entrance with the stopper after putting all food
materials into it. After removing the blade from the blender
shaft by blade remover, properly fit the blender shaft pin
with the groove of the blender mixer clutch as shown in the
fig.
Before Asking A/S
★
Please check the followings if there’re any problems during the use.
Symptom
Check Points
The blade does not
rotate while motor
sound is heard!
This maybe caused by the hardened food scraps inside of the protector as it was not washed
clean after using, or was not used for a long time. At first, unplug the power cord, and dip the
blade and protector into the hot boiled water for about 30~60 minutes and turn it on in the
clear water again.
(Be sure to keep water away from the blender.)
The motor is suddenly
stopped during the
operation!
It’s very in normal status. The motor will be automatically stopped if its temperature gets high
drastically.
Use it again after a while.
The multipurpose
blade is bent!
It seems to be defective.
This is the design of the blade.
It is common that one mixer blade is bent upward, while the other is downward one by one.
Don’t worry and use it.
The blade falls out so
often!
Slightly push the groove of the blade dented in the combination part and the opposite part
having 2 lines together to the inside of pillar using a tool. Just fasten it slightly to use, as it
would be difficult to equip or pull out the blade if fastened too much.
(Refer the instruction in pages)