7
Remote Turn-On
IMPORTANT!
Tube Driver BLUE is equipped with a special vacuum tube
warm up circuit. Whenever your system is turned on, there
will be an approximate 10 – 15 second delay before any
sound will be heard. During this warm-up time, voltage is
gently being applied to the vacuum tube heaters for proper
start-up and to insure long life.
You must connect a wire to the remote (REM) terminal located in
the center of the power connector to turn on your Tube Driver
BLUE. Your FM Radio/CD/Tape source unit normally provides a
remote amplifier turn-on or power antenna lead that pr12
Volts when you turn it on.
•
Run a wire from the turn-on lead to the REM connection
Tighten the connection
Speaker Connections
Follow these simple instructions to make your speaker
connections:
•
Using at least 16 Gauge wire, run wire from the speakers to
the amplifier(s) using the same precautions that you followed
for running the power, ground and remote wires.
•
Cut off excess wire.
•
Use wire strippers to strip approx. ¼ inch of insulation at the
end of the wires
•
Attach a proper sized U connector to each wire.
•
Securely tighten each wire to the proper speaker output
terminal using a Phillips screwdriver.
