7
Remote Turn-On
IMPORTANT!
Tube Driver BLUE is equipped with a special vacuum
tube warm up circuit. Whenever your system is turned
on, there will be an approximate 10 – 15 second delay
before any sound will be heard. During this warm-up
time, voltage is gently being applied to the vacuum tube
heaters for proper start-up and to insure long life.
You must connect a wire to the remote (REM) terminal
located in the center of the power connector to turn on your
Tube Driver BLUE. Your FM Radio/CD/Tape source unit
normally provides a remote amplifier turn-on or power
antenna lead that pr12 Volts when you turn it on.
•
Run a wire from the turn-on lead to the REM connection
Tighten the connection
Speaker Connections
Follow these simple instructions to make your speaker
connections:
•
Using at least 16 Gauge wire, run wire from the speakers
to the amplifier(s) using the same precautions that you
followed for running the power, ground and remote wires.
•
Cut off excess wire.
•
Use wire strippers to strip approx. ¼ inch of insulation at
the end of the wires
•
Attach a proper sized U connector to each wire.
•
Securely tighten each wire to the proper speaker output
terminal using a Phillips screwdriver.
