User Manual
7
7.
Connect the cable to the power supply fixed by using a screwdriver according to
the connection diagram, then loosen the screw inside the power point and plug
the cable in, make sure the sheet copper compress the power line tightly. If the
connection is incorrect, it may cause joint heating and burning off the power
cord.
8.
Connect the water inlet behind the case to the water pipe with the configured
bellows, and add a strainer on the water pipe joint in case of magnetic value
block. Also there is an exhaust pipe behind the case for needless steam to
exhaust.
6.
Operation instruction
1.
Normal using: Turn on the power, press ○1button, then press "Set Up" switch,
adjust the temperature and time, then press "Set Up" switch again to save the
data, then press "Start" switch to start cooking.
2.
Program setting: Turn on the power, press
○
1
button (or other numbers), then
press "Set Up" switch, adjust the temperature and time, then press "Set Up"
again to save the data.
2.1
To use the program: Turn on the power, press
○
1
button (or other numbers) ,
then press "Start" switch to begin.
2.2
To switch to another program, power is on, press "Start" switch to stop
cooking, press
○
2
button (or other numbers), then press "Start" switch again
to begin.
3.
Stages setting: Turn on the power, press "Stages" switch, then press
○
1
button (or
other numbers), press "Set Up" switch, the program display board display "P1",
now you can adjust the temperature and time (350
℃
and 99 minute at most),
then press "Set Up" switch again, the program display board display "A1", now
you can set up the duration of steaming (can steam 3 second at most, the
parameter are 0~30, 10=1 second) and the blank distance of each steaming (can
set 2 minute at most, the parameter are 0~120, 1=1second). After finish setting
the data of steaming, press "Set Up" switch to save the data of first stage, then
repeat the procedures above to set up all five stages, if there are any stage is not
using, just set "0" for all the parameter.
3.1
To use the program: Turn on the power, press "Stages" switch, then press
○
1
button (or other numbers) and press " Start" switch to begin. When the
machine is working under auto mode, the time display board would display
the whole time of all stages, and the temperature display board would
display the current temperature. And if you want to use the steam function,
you need to press the "Steam" switch, then it would steam base on the
preset data.
3.2
To switch to another program, the machine should be working under auto
mode, press "Start" switch to stop cooking, press
○
2
button (or other
numbers), then press "Start" switch again to begin.
