4
1.3
Power/Mode Switch
Power/Mode switch has 3 operation modes: OFF/TEST/ON.
OFF: to turn off the camera.
TEST: to set operational parameters.
ON: to work under surveillance status.
1.3.1
Enter Into Test Mode
Move power switch to “TEST” to enter into Test mode, TFT screen
displays normally. Operations can be done under this mode: set
parameters; manual photograph and record video; review/delete picture
and video; test the work area of the PIR sensor.
1.3.2
Enter Into ON Mode
Move power switch to “ON” position. Enter into “ON” mode after red&
blue indicator light flash, TFT screen is off. If animals (people or other
objects) enter the surveillance area, camera will take photos/videos
automatically according to default setting.
Note:
On “TEST” mode, the red indicator light flashes one time at
every 10seconds.When animals (people or other objects) enter the
surveillance area the blue indicator light flashes. In “ON” Mode, camera
starts successfully if red indicator light flashes 6 times and then blue
indicator light flashes 3 times continually. Later the indicator light won’t
turn on unless the voltage is too low. The camera fails to start if blue
indicator light keep lighting. Red indicator light flashes 60 seconds when
voltage is low.
1.4
Start Shooting
1.4.1
Load Battery
Install 4xAA or 8xAA alkaline/built-in batteries. Make sure the polarity
matches the sign on the cover.
Note
：
User has to purchase battery extra.
1.4.2
Insert SD card
Insert SD card into “SD” card slot. The supported memory capacity is up
to 64GB.Please make sure to format the SD card before using, in case the
upgrading procedure, picture, video and other files in the SD card will
affect the camera’s normal use.
Summary of Contents for BIG EYE D3
Page 1: ...VER 201703 ...