![background image](http://html.mh-extra.com/html/bushranger/tps261/tps261_owners-operators-manual_2835606014.webp)
_
13
_
Hot Restart
To start the engine that is already warmed up (hot restart).
1. Pump the primer bulb until fuel can be seen flowing through the fuel return line to the fuel tank. Flowing
fuel should be almost clear, not foamy or full of bubbles.
2. Turn the choke lever to the open “ ” position, and set the stop switch to the “START”(ON) position.
3. Leave the throttle trigger in the idle position and pull the starter grip.
4. If the engine fails to start after three to four pulls, follow the instruction in the Cold Starting Procedure
section above.
If the engine fails to start after you follow the above procedures, contact an authorized BUSHRANGER
dealer.
To Stop the Engine
1. Release the throttle trigger.
2. Slide the stop switch to “STOP” (OFF) position.
Idle Speed Adjustment
This Pruner is equipped with non-adjustable fuel mixture carburetor.
The idle speed is the only adjustment for the operator.
The saw chain may be moving during idle speed adjustment. Wear
the recommended personal protective equipment and observe all
safety instructions.
Keep hands and body away from the saw chain.
When the throttle trigger is released, the engine should return to an
idle speed. The correct speed is 2700 - 3300 min
-1
(or just below the
clutch engagement speed).
To adjust the engine idle speed, rotate the idle speed adjustment
screw on the carburetor.
・
Turn the idle speed screw in
(
clockwise
)
to increase the engine idle speed.
・
Turn the screw out
(
counter-clockwise
)
to decrease the engine idle speed.
If idle speed adjustment is necessary, and after adjustment the saw chain moves or
the engine stalls, stop using the Pruner immediately!
Contact your local authorized BUSHRANGER Dealer for assistance and servicing.
WARNING
POTENTIAL HAZARD
・
Engine must be running to make carburetor adjustments.
・
When engine is running, saw chain and other parts are moving.
WHAT CAN HAPPEN
・
Contact with moving saw chain or other moving parts could cause serious personal injury or death.
HOW TO AVOID THE HAZARD
・
Keep hands, feet and clothing away from saw chain and other moving parts.
・
Keep all bystanders and pets away from unit while making carburetor adjustments.
Idle Speed
Adjustment Screw