Bushranger B2600, Operator'S Manual

Page: 8 / 20

8
Installing Plastic Safety Guard
Place the Trimmer on it’s
back, push the guard onto
the shaft lining up the hole
with the guide attached to
the trimmer shaft. (Fig 1).
WARNING/ CAUTION
Installing Nylon Line
Cutter Head
• Align hole in adapter plate with hole in shaft
and install locking tool.
• Looking from the top,
thread cutter head onto
shaft (turning it anti-
clockwise) until it is
tight. (Fig. 2).
• Remove locking tool.
Installing Handle - Place the upper ‘D’ handle
(Fig. 3) over the plastic
sleeve into the desired
position, then while
holding the bottom half
of the handle in place
insert the screws and
tighten with the allen key provided.
WARNING / CAUTION
If there is excessive vibration - stop engine
immediately.
REPLACING / FITTING TRIMMER LINE
• Locate and depress the
two retaining clips that
are holding the nylon
head together. Separate
the lid from the base.
(Fig. 4).
• Take approximately 4 - 5 metres of good
quality 2.0 - 2.4mm diameter trimmer line, fold
in half and make a loop. Hold the spool in one
hand and hook the line into the slot with the
other hand. (Fig. 5).
ASSEMBLY
• Wind both lines clockwise
on both sides of the spool
ensuring that both lines
remain in their respective
channels (Fig. 5).
• To ensure the line will not
unravel, slip each end into
the slot/lug on the bottom
edge of the spool (Fig. 6).
• Insert the trimmer line into
the slots located on the
side of the spool housing
(Fig. 7).
• When in the correct
position pull the line
ends further out of the
housing. Replace the
securing lid and press
together until it clicks
into place lining up the
two locking lugs. (Fig 8).
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Fig. 6
Fig. 7
Fig. 8