Carefully read all instructions before use and save for future reference.
TO INSTALL OR REPLACE BATTERIES
Your Bushnell® TRKR
TM
T500L
Flashlight
operates on 4 AA batteries.
1. Rotate Tail-Cap counterclockwise to loosen and remove. (Fig. 1)
2. Install AA batteries in the correct orientation as shown (Fig. 1). Make certain batteries are installed correctly.
3. Replace Tail-Cap and rotate clockwise until tightened. Do not over-tighten.
+
+
–
–
+
+
–
–
FIG. 1
Tail-Cap
Your
Bushnell® TRKR
TM
T500L
Flashlight provides Momentary-On or Constant-On operation with the Button Switch located
on the body of the fl ashlight for the following lighting modes: White Spotlight mode, Red Light mode to preserve your night
adapted vision, and Blue Light TRKR
TM
mode for tracking blood trails at night or in low light situations.
OPERATION
To access Momentary-On settings:
1. Depress Button Switch half-way once and hold for White Spotlight mode; twice
and hold for Red Light mode; and a third time and hold for Blue Light “TRKR
TM
”
mode.
(Fig. 2)
2. Release Button Switch to turn off .
To access Constant-On settings:
1. Press Button Switch down fully once to “click” the White Spotlight mode “On”;
twice and “click” for Red Light mode; and a third time and “click” for Blue Light
“TRKR
TM
” mode.
(Fig. 2)
2. Depress Fully again to “click” off .
NOTE:
This intelligent switch will always default to the White Spotlight mode unless it is cycled quickly to the other settings.
FIG. 2
Button Switch
(continued on back panel)
IMPORTANT INFORMATION
1. Operating time for your Bushnell®
TRKR
TM
T500L
Flashlight depends on continuous or
intermittent use. Intermittent operation extends the run time of a set of batteries.
2. The LED is a lifetime light source. It will never need to be replaced.
3. Do not leave discharged batteries in the Bushnell®
TRKR
TM
T500L
Flashlight. This could lead to
permanent damage to the fl ashlight.
4. Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable (NiCad or NiMH) batteries.
5. It is normal for the fl ashlight’s aluminum body to get very warm during continuous use.
