3
7b
2
1
3
4
5
7a
6
Battery Level Indicator Icon (1):
Full charge
3/4 battery level remaining
1/2 battery level remaining
1/4 battery level remaining
Battery icon blinks - battery needs to be replaced, and the unit will not be operable.
BASIC OPERATION
While looking through the laser rangefinder, press and release the Power/Fire button to activate the display.
If the display appears blurry, rotate the rubber eyecup/diopter adjustment in either direction until the display is sharp for
your vision.
Placing the aiming circle (located in the center of the display) on a target at least 5-6 meters away, depress and hold the
Fire button down until the range reading is displayed below the aiming circle.
Once a range has been acquired, you can release the Fire button. The four “crosshairs” just outside the aiming circle
will go out, indicating the laser is no longer being transmitted. The display will remain on and display the last distance
measurement for about 15 seconds until the display automatically switches off to extend battery life.
You can press the Fire button again at any time to check the range to a new target. To re-fire, press the button again.
To scan the laser across an area and get continuously updated range readings, continue to hold the Fire button down and
sweep the rangefinder over multiple targets. The crosshairs outside the aiming circle will flash to indicate scan operation.
DISPLAY INDICATORS/ICONS
The Edge Rangefinder’s display incorporates the following illuminated indicators:
Battery Level Indicator (1)
Aiming Circle/Dot (2)
Active/Scan Laser Indicator (3)
Standard “Line of Sight” Distance (4)
Distance Units Indicators (5): M=Meters (blank if Feet)
Angle Indicator-incline in degrees (6)
Height Measurement (7a) / FEEt (Feet) Distance Units Indicator
(during setup only) (7b)
SELECTING UNITS OF MEASURE (METERS/FEET)
The Edge Disc Golf rangefinder measures distance in meters or feet. The unit of measure indicators for Meters (5) is
located to the right of the Standard “Line of Sight” Distance (4). If “M” (5) highlighted when ranging, distances are in Feet
(default).
To select a different unit of measure, start with the unit powered off. Press and continue to hold the Fire button. “M” or
“FEEt” will begin flashing, with the display slowly cycling through these two unit options (5,7b). Release the Fire button
when your desired display units are flashing. To select a different unit of measure, repeat this process.
AUTOMATIC SCAN
To use the Automatic SCAN feature, press and hold the Fire button, then move the rangefinder from object to object
while keeping the Fire button depressed. Automatic SCAN will cause the standard line of sight distance readout (4) to be
continuously updated as multiple objects are targeted. The Active/Scan indicator lines (3) flash while scanning.
Z-MODE HEIGHT MEASUREMENT
Z-Mode displays the elevation of the target relative to where you are
ranging from. This can help with elevated baskets or large uphill or downhill
shots that can be tough to visually gauge.
RANGING TO BASKET
35 ft
312 ft DISTANCE
VERTICLE
ELEVATION
