Bush WMNSX1016B, Instruction Manual

Page: 14 / 40

Installing your washing machine
Bringing it all together
14
Installation requirements
Levelling feet
In addition to the instructions mentioned here
,
special regulations of the relevant water and
companies may apply
.
If in doubt
,
have the
washing machine connected by a qualified
technician
.
The washing machine is heavy
-
caution when
lifting it
.
Do not lift by projecting components (e
.
g
.
washing machine door)
.
Warning : Frozen hoses may tear/burst . Do not
install washing machine in outdoor areas or
where there is a risk of frost
.
Please operate
washing machine above 0 ℃.
Lay hoses and cables in such a way that there is
of tripping over them . no risk
An additional space (approximately 120mm) is
required at the rear of the washing machine
.
This is to allow
hose and drain hose connections
.
enough space for the water
Unpacking
Unpacking your washing machine
Caution:2 people are required to unpack the
washing machine,it is recommended that gloves
are worn.
Carefully remove all packing materials including
the foam base, dispose of correctly.
Note:When opened,water droplets may be visible
in the drum etc. this is normal as each appliance
is tested before delivery.
Removing the transport bolts
Important:The bolts are designed to
support the internal components during transit
these MUST be removed before use.
2: Remove the bolts by pulling them.( 3)
transport
Fig
1: For your machine to work efficiently with
minimum vibration it should be settled on flat,
nonslippery,firm ground.
2: You can adjust the balance of your machine by
changing the positioning of its feet.
3: First,loosen the plastic adjustment nut.(Fig 5)
4: Adjust by rotating the feet upwards or
downwards.(Fig 6)
5: After the desired position has been reached,
tighten the plastic adjustment nut again by rotating
it upwards.
Note:Never put cartons,wooden blocks or similar
materials under the machine to balance
irregularities in the level of the ground.
Fig1 Fig2
•
•
•
•
•
Fig3 Fig4
Fig5 Fig6
1: Loosen the screws by rotating counterclockwise
with a suiltable wrench,(Fig 1 2)
3: When the transport bolts have been removed,
insert the plastic transport screw taps found in
the accessories bag into the holes.(Fig 4)
Installing your washing machine