Bush WMDFX714W, Instruction Manual

Page: 14 / 40

Installing your washing machine
Bringing it all together
Installing your <washing machine>
14
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
section of these instructions,
or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 257 7271.
Unpacking your washing machine
Caution: 2 people are required to unpack the washing
machine, it is recommended that gloves are worn.
a:
Carefully remove all packaging materials including
the foam base, dispose of correctly.
Note: When opened, water droplets may be visible in
the drum etc. this is normal as each appliance is factory
tested.
Removing the packing bolts
Important: The packing bolts are designed to support
the internal components during transit, these MUST be
removed before use.
a: Loosen the screws by rotating counter clockwise
with a suitable wrench. (1 & 2)
b:
Remove the bolts by pulling them. (3)
c:
When the transport bolts have been removed,
insert the plastic transport screw taps found in the
accessories bag into the holes. (4)
Adjusting the feet
a: For your machine to work efficiently with minimum
vibration it should be settled on flat, non-slippery, firm
ground.
b: You can adjust the balance of your machine by
changing the positioning of its feet.
c:
First, loosen the plastic adjustment nut. (5)
d:
Adjust by rotating the feet upwards or downwards.
(6)
e: After the desired position has been reached, tighten
the plastic adjustment nut again by rotating it upwards.
Note:
Never put cartons, wooden blocks or similar
materials under the machine to balance irregularities
in the level of the ground.
X
4
X
4
1 2
X
4
3 4
5
6
X
4
52231173_F4_ENG.indd 14 04.10.2017 10:31:41