Bush VUS34AE2O, Instruction Manual

Page: 26 / 36

If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the
Troubleshooting
section of these instructions
26
Care and maintenance
Looking after your appliance
Caution:
Make sure vacuum is turned off and power cord is
unplugged.
How to replace brush roll bar or belt
• Put the product in a flat surface, with wheel face upwards
• Use a Philips screwdriver to remove 6 screws at the bottom of the base
(Fig 1) lift off brush cover
• Rotate right end of brush roll bar and lift it out, then lift out left end of
brush roll bar. (Fig. 2)
•To replace belt ,position new belt around motor shaft (Fig. 3), loop new
belt around brush roll bar shaft at left end of brush roll bar, then insert left
end of brush roll bar first, align brush roll bar end cap with slot to make it
fits into position, press right end of brush roll bar into position (Fig.4)
• Refit brush roll bar cover and screw in 6 screws (Fig 5)
Fig 2
Fig 1
1
2
3
4
5
6