Bush MSBSWTDB20, Instruction Manual

Page: 20 / 40

Installing your refrigerator
Bringing it all together
Transportation
Caution: 2 people are required to unpack
and handle the appliance, it is
recommended that gloves are worn.
.
The appliance should be transported only in an
upright position. Do not tilt the appliance greater
than 45 degrees . The packaging as supplied must
be intact during transportation.
.
After transporting the appliance, leave it for at
least 4 hours before switching on to allow the
cooling system to settle. Failure to comply could
result in damage to the appliance.
.
Do not move the appliance by pulling the door or
handle as it may damage your flooring and wall
coverings etc.
.
Empty any water in the drain tray before moving
.
Make sure that the defrost water pipe at the back
of the product is fixed to the plastic evaporating
pan on the top of the compressor, to avoid defrost
waterspillage on the floor.
.
Ensure the electrical cable is not caught under
the appliance during and after moving
.
Carefully remove all packaging materials
including the foam base, dispose of correctly
Installation
.
Ensure sufficient spacing is provided for the
appliance to be installed. Leave space on both
sides (5cm), back (5cm) and above the
appliance (5cm) to ensure proper ventilation
and door opening. See fig. 1&2
.
Do not place the appliance near a heat source
or in direct sunlight
.
Do not put any heavy objects on top of the
appliance. It will damage the appliance.
.
Do not install the appliance in a moist or wet
place. It should be installed on a smooth surface
to avoid excessive vibration and noise.
.
The appliance is equipped with four castors on the
bottom side for easy movement. Ensure the two
leveling feet on the front side have been screwed
upwards. Then move the appliance to the right
location.
.
Screw the leveling feet downwards to fix the
appliance in place.
Fig.2
Fig.1
50mm
50mm
50mm
50mm
20 Installing your refrigerator
Troubleshooting