Bush LSBCHP, Instruction Manual

Page: 14 / 34

Installing your Ceramic Hob
Bringing it all together
Installing your Ceramic Hob
14
If you require any technical guidance or find t at your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
CAUTION:
TO REDUCE THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE COVER
(OR BACK). NO USER-SERVICEABLE
PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK).
NO USER-SERVICEABLE PARTS INSIDE.
REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
INS TALLATION
Before installation
Installation and test must be carried out by professional technician. And the hob must be 150mm far away
from the wall or anything else. To avoid interference of taking the households when cooking, in the
place 300mm from the both sides of the hob must not be put any furniture or separate board. And the
both sides of the hob should 300mm at least far away from the wall. The thickness of the table used to
mounting the hob should be 30cm at least, and it should be heat resisting or be covered by a the heat
resisting material.
The rating plate
Make sure that the voltage and capacity of the power line conform to the data shown on the rating
plate. Do not remove this plate for any reason.
POSITIONING OF THE HOB