Bush DW12-TFE3, Service Manual

Page: 29 / 50

Page 28 of 49
Service Manual
Model No: DW12-TFE3 Series
Issue
Rev.
1-12. Turning on the Appliance
1-12-1. Switching the dishwasher ON
--Close the door after loading the appliance.
--Set On-Off button "B" to On. The indicator light "A" comes
on.
--Rotate the dial to select the required programme. The
time-remaining indicator displays the time required for the
programme you have selected. After 3 seconds the
appliance emits a short warning signal, and starts the
programme. The indicator light "A" starts to blink.
Warning
When the dishwasher is on, if the programme to which the dial is pointing cannot be carried
out, you must rotate the dial to another programme and then back to the programme you
require.
1-12-2. End of programme
Six beeps will indicate that the wash cycle has finished and the indicator light "A" comes on.
1-12-3. Switching the dishwasher OFF
Several minutes after the programme has ended:
--Set On-Off button to Off.
--Open the door.
--Remove dishes, etc. when they have cooled down.
Notice:
When the appliance is already underway press the button "B" for 3 seconds, all of the
settings will be cancelled.
1-12-4. Interrupting the programme
--Open the door. Caution! There is a risk of water coming out from inside the appliance. Do not open
the door fully until spray arm has stopped rotating.
Caution!
There is a risk of water squirting out from inside the appliance. Do not open the door fully
until spray arm has stopped rotating.
--When you open the door, the dishwasher will beep ten times every thirty seconds.
--If the appliance has already heated up or the hot water was switched ON and then the appliance
door opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door
may open due to expansion.