Page 4
General operation
Battery installation
1:
Remove the battery compartment cover carefully .
2:
Install
8
x
‘C’
size batteries
(UM-2 or equivalent)
while observing the correct polarities .
NOTE:
There is an engraved diagram showing
battery installation directions inside the battery
compartment .
3:
Replace the battery compartment cover .
NOTE:
The mains cable must be detached
from the DC mains socket of the player for the
batteries to power the unit .
Leaking batteries may damage the battery cabinet
and the player as a whole
,
so they should be
removed from the cabinet when becoming flat or
when the player is not to be used with batteries for
some time .
DC Mains operation
This unit is supplied with a DC mains adaptor.
1:
To connect the power insert the mains socket jack
into the rear of the unit
(18)
.
2:
Insert the
UK
plug into a household power socket and
switch the power
ON.
Standby mode
Using the standby mode will save power when the unit
is not in use.
1:
When the unit is switched
ON
for the first time
STANDBY
mode will be active .
2:
To wake the unit from the
STANDBY
mode, press the
POWER/FUNCTION
button
(15)
. The unit will wake
and the
POWER
indicator next to the display will
illuminate .
3:
To enter the
STANDBY
mode press and hold the
POWER/FUNCTION
button
(15)
for at least
2
seconds .
The
POWER
indicator will dim .
NOTE:
This unit is designed to enter
STANDBY mode automatically after 20 MINUTES
of inactivity . Press the POWER/FUNCTION (15)
button to wake the unit .
Volume controls
1:
To increase the volume level press the
VOL+
button
(3)
repeatedly, or press and hold for rapid advance .
2:
To decrease the volume level press the
VOL-
button
(3)
repeatedly, or press and hold for rapid advance .
Radio operation
1:
Wake the unit from
STANDBY
mode if required .
2:
Press the
POWER/FUNCTION
button
(15)
repeatedly
until you see
‘87.5’
or another radio frequency on the
display .
3:
Extend the antenna fully, and angle for best reception
(you may need to adjust once tuned to a station)
.
4:
Tune to the required station using the
TUNING
+ / -
buttons
(11)
. Pressing either button once advances
the frequency in
0
.
05MHz
increments . Press and hold
either button to search up or down the frequency
range, until a station is located . When a station is
found it will begin playback . You can stop the scan
at any time, by pressing either
TUNING
+ / - button
again .
User instructions
Summary of Contents for CBB318i
Page 1: ...Instruction Manual CBB318i...