Page 6
Mains connection
Connecting mains power
1:
Connect the attached mains plug to a
UK
mains
power supply outlet .
2:
Switch the power outlet
ON.
Standby mode
1:
Press the
STANDBY
button
(3 Unit & 12 Remote)
to
wake the unit from
STANDBY
mode .
2:
To enter
STANDBY
mode press either
STANDBY
buttons
(3 Unit & 12 Remote)
.
NOTE:
As part of the power saving mode the unit
will enter STANDBY mode automatically after 20
minutes (approx) of no audio output .
General operation
Switching inputs
Follow the below steps to switch inputs between : TV,
Auxilliary, Coaxial or Bluetooth .
1:
Ensure the Sound bar is powered
ON.
If not press the
STANDBY
button
(3)
or remote
(12)
.
2:
Press the
SOURCE
button
(5
,
21)
repeatedly until you
reach the required input mode . The input source is
denoted by a coloured
LED
light
(1)
. See below table .
TV input:
TV
RED LED
Auxiliary input:
AUX
GREEN LED
Coaxial input:
COAX
PURPLE LED
Bluetooth input:
BT
BLUE LED
NOTE:
When switching inputs there will be a 3
second pause after selecting BT while the unit
scans for paired devices .
Adjusting the volume level
1:
To increase the volume level press the
VOLUME
+
button
(4 Unit or 17 Remote)
repeatedly or press and
hold for fast adjustment .
2:
To decrease the volume level press the
VOLUME
-
button
(4 Unit or 17 Remote)
repeatedly or press and
hold for fast adjustment .
Sound effect presets
1:
During playback press either
MOVIE (15)
or
MUSIC
(20)
buttons once or press and hold the
FLAT/TV
(14)
button to activate the sound
EQ
for that type of
viewing .
2:
To disable the sound
EQ
mode press the
FLAT/TV (14)
button .
Mute function
1:
Pressing the
MUTE
button
(22)
on the remote will
temporarily silence the audio output .
2:
Press the
MUTE
button again to resume the audio
output .
Pairing a Bluetooth device
Before you can use the sound bar with your phone or
other bluetooth capable device you will need to pair the
device to the sound bar .
1:
Press the
SOURCE
button
(5
,
21)
repeatedly until you
see the
BLUE LED
(1)
appear .
2:
When selected the
BLUE LED
will flash to indicate it
is in pairing mode, or trying to connect with an already
paired device .
3:
Enable the Bluetooth function on your audio device
and search for a device labelled
‘CBAR2BT’
in the
available list .
4:
Select and enable pairing for the
‘CBAR2BT’
device . If
prompted for a password enter
‘0000’
.
5:
If pairing is successful the
BLUE LED
will stop
flashing .
6:
If the connected device goes out of range, the sound
bar will attempt to connect for
2
minutes . When the
device comes into range the sound bar will reconnect
again automatically .
7:
To remove a paired device using only the sound bar,
press and hold the
PAIR
button
(13)
on the remote
control . The
BLUE LED
will start to flash again .
User instructions
Summary of Contents for CBAR2
Page 1: ...Instruction Manual CBAR2...
