Installation
Fi
x
ing
The appliance must be installed on a
perfectly level supporting surface.
- Apply the one-sided self-adhesive
sealing tape supplied all the way round
the lower edge of the cooking surface
along the outer edge of the glass ceram-
ic.
- Screw the 4 worktop mounting brackets
on the bottom of product panel.
Electrical connection
Before proceeding with the electrical connection, verify
that the current carrying capacity of the system and the
socket is adequate for the maximum power rating of the
hob.
- Electrical installation of the residence and the plug in
use must be earthed and conform with safety regula-
tions.
- If there is no dedicated hob circuit and fused switch,
they must be installed by a qualified electrician before
the hob is connected.
- The fused switch must be easily accessible once
the hob has been installed.
- Do not use adaptors, multiple sockets and/or exten-
sion leads.
- This appliance conforms with the requirements ofthe
following EEC Directives:
1. Vitroceramic hob EEC/73/23 and 93/68,
EEC/89/336 relating to
radio interference,
2. EEC/89/109 relating to contact with foods.
- A circuit breaker with a contact opening of at least
3mm, rated 25A and of delayed functioning type must be
installed inside the supply circuit.
- For the knob controlled vitroceramic hob, the cable
must be 3X2,5mm² for single phase / 60227 IEC 53. You
will find the connection diagram shown on the bottom of
your appliance.
- During installation, please insure that isolated cables
are used. An incorrect connection might damage your
appliance. The guarantee will not cover such damages.
- All repairs must be carried out by authorised service
personal or a qualified electrician.
- Unplug your appliance before carrying at main-
tenance. For reconnection, follow the connection
diagrams strictly.
- Cooking hobs are provided with supply cord.
* This appliance must be earthed.
* For this connetion a power lead of wire type
H05V V -F should be used.
2
2
2
