Bush BFSNB12B/W, Instruction Manual

Page: 35 / 40

Care and maintenance
Looking after your appliance
Care and maintenance
33
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
or online at www.argos-support.co.uk If you still require further assistance, call one of our experts on 0345 257 7271.
FAULT POSSIBLE CAUSE TROUBLESHOOTING
Whitish stains remains on
dishes.
Not enough detergent used.
Use the correct amount of detergent, as instructed
in the programme table.
Rinse aid dosage and/or water softener
setting set too low.
Increase rinse aid and/or water softener level.
High water hardness level. Increase water softerner level and add salt.
Salt compartment cap not closed properly. Check that the salt compartment cap is closed
properly.
Dishes do not dry.
Drying option is not selected. Select a programme with a drying option.
Rinse aid dosage set too low. Increase rinse aid dosage setting.
Rust stains form on the dishes.
Stainless-steel quality of the dishes is
insufficient.
Use only dishwasher-proof sets.
High level of salt in wash water.
Adjust the water hardness level using water hardness
table.
Salt compartment cap not closed properly. Check that the salt compartment cap is closed
properly.
Too much salt spilled in the Dishwasher
while filling it with salt.
Use funnel while filling salt to the
compartment to avoid spillage.
A poor mains grounding. Consult a qualified electrician immediately.
Detergent remains in the
detergent compartment.
Detergent was added when the detergent
compartment was wet.
Make sure detergent compartment is dry before use.