Bush AG56SBX, Instruction Manual

Page: 29 / 46

Functions
Simple everyday use
Functions 29
or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 257 7271.
Assembling the grill heat shield
Hold the heat shield with the warnings facing upwards.
There are two small slots on the right and left side of
the rear edge of the shield, as shown in the figure.
There are two screws equipped with bushes under the
oven control panel. Align the bushes with the assembly
slots so that the shield is located between the control
panel and the bush. Push the shield towards the
appliance until it is firmly in its place.
Cooking
• The grill burner creates a source of heat at a
constant rate and cannot be adjusted between the
maximum and minimum positions. When switching
the grill burner off, turn the knob in a clockwise
direction to the “0” position.
• Place a tray on the shelf below the grid in order to
collect the fat during grilling.
• Place the wire grid on the topmost shelf, provided
that the food does not touch the grill burner.
• Preheat the grill on a full setting for a few minutes
before sealing steaks or toasting. Food should be
turned, as required, during cooking.
• Food should be thoroughly dried before grilling
to minimize splashing. Brush lean meats and fish
lightly with a little oil or melted butter to keep them
moist during cooking.
• Food should be placed in the centre of the grid to
allow for maximum circulation of air.
• Never cover the grill pan or grid with foil as this can
lead to grill fires.
• If your appliance has a grill pan and handle set as
an accessory, refer to the accessories section for its
usage.
WARNING : Ensure that the grill is switched off
before closing the door.
Oven Lamp
There is an oven lamp inside the oven to illuminate the
cooking area. Press the lamp button to switch the lamp
on or off.