Bush Palace
Eagle
Setup Guide
© 2017 Bush Palace Camper Hire
6
RAISING THE ROOF
•
Remove any load from the roof rack
•
Unlock front boot, side boot, shower and water filler.
•
Undo the roof clips at each corner.
•
If you intend to use the privacy screens, unzip them now and let them drop down from their
bags front and rear.
•
Using the winding handle from the front boot, wind the camper roof up about 6 inches (winder is
inside a small door at the rear left of the camper)
•
Check to make sure nothing is snagged.
•
If using privacy screens insert the ridge poles into the fitting that sits below each bag (it's much
easier to do this now). Support this with a vertical pole.
•
Raise the camper roof fully, until the green tension indicator wire at the left rear of the camper is
almost tight
•
Return the winder handle to front boot and close winder hatch.
•
Insert a roof support (stored under mattress) in two opposite corners
Roof clip
Winder handle
Ridge pole – 1
Ridge pole – 2
Roof tension
indicator
Support pole in place
