ASSEMBLY
DSP8/10/12 10/19
Assembly Section 3-5
© 2019 Alamo Group Inc.
A
SS
EM
B
LY
Wear Plate Option
Bush Hog offers an optional wear plate located on the lower ground engaging surface of each side plate.
1. Bolt one wear plate (#1) to the right and left side
plate (#2) facing the inside of the Drag using
two 3/4” x 2” hex bolts (#3) and nylock nuts
(#4).
Tractor Hook-up
Crushing hazard between tractor and implement. Do not allow anyone to stand between
tractor and implement while backing up to an implement. Do not operate hydraulic controls
while someone is directly behind the tractor or near the Pull Type Drag Scraper.
Always make sure the hitch pin is secured with a keeper clip and the safety chain is attached
to the tractor. Not doing so can result in the unit becoming unhitched and out of control.
Always secure the scraper in the up position with the cylinder transport lock when
transporting. Hydraulics can seep or burst dropping the scraper blade resulting in loss of
control.
Always engage parking brake, shut off tractor and remove key before dismounting from
tractor to hook up equipment.
1. Back tractor within close proximity of clevis.
2. Shut off tractor and operate control arms back and forth to release all hydraulic line pressure.
3. Attach scraper hoses to the tractor hydraulic system.
4. Return to tractor, start tractor and operate control lever to raise rear wheels up until the scraper hitch aligns
with tractor drawbar.
5. Back tractor up to the hitch until hitch holes align with drawbar hitch hole.
6. Engage parking brake, shut off tractor and remove key before dismounting from tractor to hook up
equipment.
7. Attach scraper hitch to tractor with customer supplied hitch pin and safety chain to tractor. Make sure hitch
pin is secured with a hitch pin keeper and safety chain is secure to the tractor hitch frame.
Summary of Contents for DSP10
