Bush Hog DHP10, Operator'S Manual

Page: 22 / 68

INTRODUCTION
DHP8, DHP10, DHP12 05/21 Introduction Section 2-4
© 2021 Alamo Group Inc.
IN
TR
O
D
U
C
TI
O
N
Once you have finished using your disc, travel to storage area, lower it out of transport position parking it on a
level surface. Clean it, service it, and make sure it is ready for the next use by replacing any parts that may
have become excessively worn or damaged during field operation.
FEATURES
• Square and rectangle tube steel frames and gang tubes
• Adjustable gang angles, front and rear
• Variable blade spacings available: You get the best of both worlds.
9” front and rear gangs for tough-to-cut “New Ground”
7-1/2” front and rear gangs for finer soil finishing
9” front gangs - 7-1/2” rear gangs
• Notched disc blades for maximum cutting action
• 1-1/8” square, high carbon steel gang axles
• Available in tractor colors
• Optional disc scrapers
• Center Sweep Kit
• Dual Wheel Transport Kit
NOTE: All reference made in this manual to right, left, front, rear, top or bottom are as viewed facing the
direction of forward travel with implement properly attached to tractor.Attention Owner/Operator