Commissioning
Product manual 2CKA001473B8724
│
19
5. Change the name of the device if required and click "Save".
– The radio starts again.
– The time (CET) is displayed after 2 minutes. The reference >“Access Point mode
deactivated. "Radio mode is now active!" is displayed.
– If necessary, the radio carries out an automatic Firmware update.
6. Wait for approximately 2 minutes, until the date and time are displayed!
– The radio is ready.
7. Press the "ON/OFF" button to listen to the first pre-set radio station.
7.4
The device cannot find a WLAN connection
Fig. 10:
No WLAN connection
1. Wait a few minutes if the device cannot find the WLAN connection immediately.
2. If it still cannot find the WLAN connection, restart the device.
– Press the entire rocker switch for approximately 5 seconds.
3. Check the network name (SSID) entered and the password.
4. Carry out initial commissioning again.
NOTE
If you press the "ON/OFF" button during the search, the device changes into the
"Firmware update" function.
If you press the "ON/OFF" button again, the device changes to the main menu.
The device can be restarted from all functions.
7.5
Setting up the device
To set up your device you have two options:
1 Setting up the device manually, see chapter 9.4 “Functions of extended operation / Setting
up the device manually“ on page 27.
2 Setting up the device via WLAN, see chapter 9.5 “Setting up the device via WLAN network“
Nein, Radio ne
Konfiguration prüfen
Keine WLAN-Verbindung,
weiter versuchen?
SSID + WLAN-Passwort:
Bitte prüfen!
... u starten
