DRILL PRESS MANUAL
We reserve the right of the amendment addition and deletion of the
specifications, explanatory wording, etc. printed in this manual
14
Your drill press comes with a depth stop adjustment for use when drilling.
1.
Loosen the depth collar lock knob as shown in
Figure 15
.
2.
Secure the wood stock you will be drilling onto the drill press table.
3.
With the desired bit installed, lower the spindle until the tip of the bit just touches the
wood stock you will be drilling. Hold the spindle in this position.
4.
Turn the depth collar to the desired depth indicated by the scale on the collar. Secure
the collar by tightening the lock knob.
5.
Remove the wood stock and test the depth stop by measuring how far the spindle
travels when the handles are rotated as shown in
Figure 16
.
Figure 15 Figure 16
You can also lock the spindle in the down position for operations such as spindle sanding.
1.
Loosen the depth collar lock knob as shown in
Figure 15
.
2.
Rotate the spindle to the desired depth and hold it steady.
4.
Rotate the the collar clockwise until it stops, and tighten the lock knob.
5.
Slowly release the drill press handle. The spindle should not move.
Table Adjustment
The table can be adjusted for height, rotation and angle.
1.
Loosen the support bracket lock knob. Turn the table hand crank to lift or lower the
table as shown in
Figure 17
.
2.
Always lock the support bracket in place before operating the machine.
Adjust rotation:
1.
Loosen the lock handle located under the table as shown in
Figure 18
. Rotate the
table the desired amount.
文件使用
"pdfFactory Pro"
试用版本创建
