Burstner Ixeo Time IT 590, Instruction Manual

Page: 72 / 274

72
T-Modell - 17/18 - Ausgabe 09/17 - 2891569 - BUE-0029-19EN
Living
6
6.9.5 Holder, rotatable
The flat screen is fastened to a holder with a rotatable joint.
Positioning:
„
Swivel the flat screen into the desired position.
Removing flat screen:
„
Press and hold latch (Fig. 78,1) to the right.
„
Remove flat screen upwards.
6.10 Ventilation
Condensation Ensure that there is a continuous exchange of air by providing frequent and
efficient ventilation. This is the only method for ensuring that condensation and
resulting mould is not formed during cool weather. During the colder season,
a pleasant living climate is created if heating output, air distribution and venti-
lation are synchronised. To avoid draft close the air outlet nozzles on the dash-
board and set the air distribution of the base vehicle to air circulation.
If the vehicle is laid up for a longer period, occasionally ventilate it well, espe-
cially in summer as heat accumulation can occur. Do not only air the interior,
but also the storage spaces which are accessible from the outside. Air the
parking place as well if the vehicle is parked in a closed space (e.g. garage).
The occurrence of condensation could lead to the formation of mould.
Fig. 78 Holder (rotatable)
X
The oxygen in the vehicle interior is used up by breathing and the use of
gas operated appliances. That is why the used air must be replaced per-
manently. For this purpose, forced ventilation options (e.g. skylights with
forced ventilation, mushroom-shaped vents or floor vents) are fitted to
the vehicle. Never cover or block forced ventilations from the inside or
outside with objects such as e.g. a winter mat. Keep forced ventilations
clear of snow and leaves. There is a danger of suffocation due to
increased CO
2
levels.
Z
Although sufficient ventilation is provided, in certain weather conditions,
condensation can form on metal objects (e.g. screwed connections in the
floor).
Z
Additional cold spots can occur at thermal "bridges" (e.g. mushroom-
shaped vents, skylight edges, sockets, filler necks, flaps, etc.).