Burstner Ixeo Time IT 590, Instruction Manual

Page: 175 / 274

175
T-Modell - 17/18 - Ausgabe 09/17 - 2891569 - BUE-0029-19EN
Appliances
9
Switching on:
„
Press and hold the On/Off button (Fig. 225,1) for about 2 seconds. The
refrigerator switches on and the previously set operating mode is dis-
played.
Selecting operating mode:
„
Press the illuminated button for the desired operating mode (Fig. 225,2 - 4)
or the automatic mode "AES" (Fig. 225,5) (only in the case of AES version).
In the case of the AES version, the automatic energy selection is carried out
in the following order as a function of the availability of the energy sources:
z
12 V solar (special equipment)
z
230 V AC
z
12 V DC
z
Gas
Setting the refrigerating
temperature:
„
Use the cooling level button (Fig. 225,7) to set the refrigerating tempera-
ture. The cooling level indicator (Fig. 225,8) shows the selected thermostat
setting.
Switching off:
„
Press and hold the On/Off button (Fig. 225,1) for about 2 seconds.
„
If the refrigerator had been operated with gas: Close the gas isolator tap
"Refrigerator" and the regulator tap on the gas bottle.
Refrigerating temperature
control
When turned on the first time the refrigerator automatically selects the middle
thermostat position. This position can be adjusted manually using the cooling
level button (Fig. 225,7). It takes a few hours till the refrigerator reaches its
normal operating temperature. When changing over to another operating
mode, the thermostat setting is kept.
Frame heater (depending
on the model)
High external temperatures and high humidity can cause drops of water to
form on the metal frame of the freezer compartment. To prevent any possible
corrosion, the freezer compartment is equipped with a frame heater.
The following options are available for operating times of the frame heater:
z
2 hours
z
5 hours
z
Continuous operation (switched on for 30 minutes, then for 5 minutes on
and 5 minutes off in alternating intervals)
Setting operating time:
„
Switch on the frame heater for a 2 hour period: Push the frame heater illu-
minated button (Fig. 225,6) once. One bar is lit on the cooling level indi-
cator (Fig. 225,8).
„
Switch on the frame heater for a 5 hour period: Push the frame heater illu-
minated button (Fig. 225,6) twice. Two bars are lit on the cooling level indi-
cator (Fig. 225,8).
„
Setting frame heater for continuous operation: Push the frame heater illu-
minated button (Fig. 225,6) three times. Three bars are lit on the cooling
level indicator (Fig. 225,8).
Z
If the refrigerator shall be operated with gas: Open the regulator tap on the
gas bottle and the gas isolator tap "Refrigerator".
Z
When the frame heater is turned on, it uses about 4 Watts, including in gas
operation. To avoid running down the living area battery, in gas mode
refrain from running the frame heater in continuous operation or turn the
frame heater off entirely.