Burstner CityCar 2016, Instruction Manual

Page: 86 / 150

86
City-Car - 15/16 - Ausgabe 12/15 - 2616861 - BUE-0090-00EN
Appliances
9
9.2.3 Hot-air heater with operating unit CP plus
Operating unit The operating unit is divided into two sections:
z
Display
z
Operating buttons
After being switched on, the most recently set values/operating parameters
are activated.
If no button is pressed, the operating unit switches to stand-by mode after a
few minutes.
If the time is set, the display in stand-by mode alternates between the time and
the room temperature set.
After being switched off, the display in the control unit may remain active for
several minutes since the heater is still running.
Operating buttons The operating buttons have the following functions:
Z
If there is a risk of frost and the heater is not in operation, empty the boiler.
Z
The circulation fan is automatically switched on when the hot-air heater is
activated, and it stays on. This puts an immense strain on the living area
battery, if the vehicle is not connected to an external 230 V power supply.
Take into consideration that the living area battery only has limited
reserves of energy.
Z
The hot-air heater can even run on an empty boiler.
Z
If the power supply to the heater was interrupted, the time must be reset.
Fig. 55 Operating unit
1 Display
2 Rotary push button
3 Back button
Button Button operation Function
Rotary push
button
(Fig. 55,2) Turn to the right Menu is run through from left to right
Values are increased
Turn to the left Menu is run through from right to left
Values are decreased
Press briefly Selected value is saved
Menu item is selected for changing
values (selected menu item flashes)
Press (3 seconds) Switch on or switch off
Back button
(Fig. 55,3) Press Return from a menu item without sav-
ing values