Burster DIGIFORCE 9311, Operation Manual, Page: 15 / 216

15
of 216
2.10 Error messages when the unit is powered up
During boot-up, the DIGIFORCE
®
9311 may display certain error messages.
The following errors mean that the DIGIFORCE
®
9311 must be sent in for checking and possibly repair:
German error message English error message
"Nichtflüchtige Daten korrupt" "Non-volatile data error"
"Abgleich Fehler" "Calibration error"
"EEPROM von Analogplatine ist leer“ "EEPROM of analog board is empty"
"Fehler beim Lesen der MAC Adresse" "MAC Address Reading Error"
In any of these cases, please call our Service department on (+49) 07224 645-53 or
email: service@burster.com (Germany only). If you are outside Germany, you should contact your burster
agent (see also www.burster.com ).
Please refer to the additional guidance on packaging in section 2.7 "Unpacking" on page 14.
If any of the following error messages arise, you must contact our Service department (Germany only). If
you are outside Germany, you should contact your burster agent (see also www.burster.com ).
German error message English error message
"Analogplatine wurde getauscht" "Analog board has been exchanged"
"Fehler beim Lesen der Seriennummer" "Serial Number Reading Error"
For further information, please refer to section 2.2 "Customer Service" on page 11.