Assembly Manual
DIGNA
Seite 5
Now unscrew the two Torx M3 x 4 screws from the top PCB again, pick up the top silver frame
and glue it on the top PCB after peeling off the protective foil. You will notice that it gets a little
bit "tight" when placed in at the area around the BURSON operational amplifier. This is intended
and serves as an additional safeguard against accidental falling out. However, with the help
of a fingernail (around the BURSON), the cover can easily be pressed flush.
After re-screwing the two screws and plugging in the tubes, everything is now ready for enjoying
your vinyl music. Congratulations.
Anbieter • Vendor
Jürgen Grau • Mr.Nixie • Ortsstraße 13 • D-07429 Rohrbach / Thüringen • Germany
[email protected] • http://www.Nixiekits.eu
Dieser DIY Phono Vorverstärker wurde in Deutschland entwickelt und zusammengestellt
This Phono preamplifier kit was carefully engineered and assembled in Germany
