6
Before You Begin
Remove contents from box. Remove the foam
separators that protect the components from
damage during shipping. Inspect the contents of
the box for scratches in the paint, dents or kinked
cables that may have occurred during shipping.
Because these vehicles are 95 percent assembled
and packed at the factory, there should not be any
problems, even if the box has a few scars or dents.
MAKE SURE POWER SWITCH IS TURNED “OFF”
BEFORE CONDUCTING ANY MAINTENANCE
PROCEDURES.
Burromax recommends assembly and maintenance
by an adult. Allow up to 30 minutes for assembly.
Standard model TT250
allow up to 12 hours
for initial charge (see page
10-12
for charging
information).
Li-ion Model TT350R
Allow up to 4 hours for initial
charge (See page
10-12
for charging information
)
During assembly, you can familiarize yourself with
the vehicles components and design.
Enjoy the process and take your time to insure all
components are safe and secure!
REQUIRED TOOLS
WARNING:
DO NOT USE
NON-Burromax PRODUCTS
WITH YOUR Burromax
vehicles. These vehicles have
been built to certain Burromax
design specifications. The
original equipment supplied at
the time of sale was selected
based on its compatibility with
the frame, fork and all other
parts. Certain after market
products may or may not be
compatible and may void your
warranty.
ADDITONAL PARTS
LOCATION
Located within the center
packing foam you will find the
charger and tool kit. Within
this package the handel bar
clamps and hardware are also
located. DO NOT DISCARD.
4mm and 5mm and
6mm Hex Key wrenches
(Included)
10mm,12mm 14mm and 17mm
open wrench (Included)
Screwdriver
(included)
Your local Service Stations will have this item
