Operation
page
24
In-call dial
If during a call, you want to make another call without ending the
current call, follow this procedure:
1 Press the recall button on the phone (or quickly tap the hook
switch) and the display will show:
Call(s) held and multiparty (conference) calls
Note: Multiparty calls are supported only on non-’L’ models.
If one or more calls are held after accepting a waiting call or dialling
another number, you have the following options:
• Press the recall button on the phone (or quickly tap the hook
switch). The display will show “Reject?”. Either:
• Press
0
to reject the current active call and return to the held
call(s), or
• Press
#
to display “Add?”. Then press
0
to add the held call(s)
to the current call and provide a multiparty call, or
• Press
#
twice and the display will show “Swap?”. Press
0
to
place the existing active call on hold and connect to the held
call(s).
Note: If you try to add a party to a multiparty call and the call is an-
swered by voicemail, you should disconnect the call, otherwise the
conference may be recorded by voicemail until it becomes full.
2 Dial the number, speed dial or use the phonebook and the call will
be connected in the normal way. Once connected, the display will
show ‘1 active call’ as well as the number of held calls.
• If it is not possible to connect the call, e.g. the line is busy or
there’s no reply, you will be automatically returned to the held
call(s).
• If the new call is connected, use the Call Held options (as
discussed on the left) to either reject, create a multi-party call or
switch between calls.
Notes: During in-call option selection, to return to a previous
option press the
key. Hanging up the phone will terminate all
calls (held, calling, active or waiting).
