Operation
page
Method for (tariff) timer reset
This group of options control how the tariff timer should be reset.
•
Show status
- dial
0#38410
- Indicates the current setting.
•
Set to manual
- dial
0#38420
- In this mode, the tariff timer can
be reset either by using the ‘Reset now’ option or by sending a
text message (reset the tariff timer) formatted as ‘
pppp
re
’ where
pppp
is the Terminal PIN code - see
for more
details.
•
Set to automatic
- dial
0#38430
- In this mode, the tariff timer will
be reset each new month at the start of the day specified using
the ‘Day of reset’ option.
•
Day of reset
- dial
0#38440
- Determines the day of each month
from which the tariff timer should reset (when the ‘Set to automatic’
option is set). Valid entries are ‘1’ to ‘28’, press
#
to save.
•
Reset now
- dial
0#38450
- Resets the tariff timer immediately. This
action can also be achieved by either temporarily removing power
from the unit or by sending a text message (reset the tariff timer)
formatted as ‘
pppp
re
’ where
pppp
is the Terminal PIN code - see
for more details.
Restrict call time
This group of options allow you to set a time limit that should not be
exceeded by any single outgoing call and also determine the action
that should occur if the limit is exceeded. The actions of these op-
tions are independent from those of the
.
•
Set new time limit
- dial
0#3910
- Determines the number of min-
utes permissible within a single outgoing call. Valid entries are ‘1’
to ‘60’ minutes, press
#
to save.
•
Action taken at time limit
(dial
0#3920
)
- This group of options
determine what should happen when the restrict call time limit is
reached.
•
Show status
- dial
0#39210
- Indicates the current setting.
•
Set to no action
- dial
0#39220
- Disables the restrict call time
feature. The
option will still show the time of the
last call when selected.
•
Set to end call
- dial
0#39230
- When selected, the call will
be automatically terminated when the restrict call time limit is
reached. If this option is selected, the recall/flash call control is
automatically disabled. See
0#5270
).