4 - 5
B
1. Turn the water flow control handle to increase/decrease
the water flow and turn on/off.
2. Turn the temperature control handle to increase/decrease
the water temperature.
3. The temperature control knob is pre-set the auto stop at 42°C to
avoid scalding.
However, if for any reason the setting is removed it is important to
follow “Temperature Setting” procedure to reset.
Operation
HOT
COLD
TEMPERATURE
CONTROL
WATER FLOW
CONTROL
DL
O
n
C
TH
AB
H S
OW
ER
TO
H
27
0°
SHOWER
BATH
Temperature Setting
The temperature control handles on this product are factory set and should require no adjustment.
However, if for any reason the handles and/or the cartridge is removed it is important the following procedure is followed.
1 ) Remove the temperature control handle, metal block (see Fig 1).
2 ) Rotate the exposed thermostatic spindle (clockwise for cold, and anti-clockwise for hot), until the maximum desired showering temperature is set.
The suggested maximum “pre-set” temperature is 42°C (see Fig 2).
3 ) Without any move at the spindle, replace the metal block so that limit stop up to the right hand side of the limit stop on the cartridge (see Fig 3).
4 ) Then refit the temperature control handle.
METAL BLOCK
SPINDLE
LIMIT STOP
1
2
3
4
Maintenance (Thermostatic Cartridge)
* After a long time usage of thermostatic valve, there will be some waste debris from the water pipe on and around the check valve or
thermostatic cartridge, which will affect the flow and sensitivity of automatical temperature adjustment. Please take out the thermostatic
cartridge, and clean the cartridge strainer.
* To avoid damage, please remove all chrome parts before any maintenance takes place.
Maintenance (Filter & Check valve)
A) Cutoff the Hot & Cold supply at the isolating valve.
Disconnect the hot & cold water supply from the valve.
B) Take down the valve from the feet.
C) Take out the filter, check valve.
D) Clean the filter and check valve with clean running water,
dry and lightly grease the seals. (only use silicone grease)
E) Put back all of the parts in sequence.
FILTER
CHECK VALVE FIXING NUT
“ O” RING